Fixing your last bash command

Guy I know - Oliver - command line ninja . Never makes a mistake. Can configure an AWS in a single long bash command. Typing speed through the roof. Bet you know someone like that too.

We mere mortals make mistakes and, while it's always good to learn from your mistakes, the first thing you have to do is fix them .

And to fix them you need to learn how to fix them.

Simple replace

Say you've typed an impossibly long command into the terminal with one irritating mistake. For me, it's usually something to do with xargs or curl

curl -s -I -X POST https://en.wikipedia.org/wiki/CURL | grep HTTP | cut -d ' ' -f 2

Not the greatest command - but say I couldn't spell wikipedia...

curl -s -I -X POST https://en.wikpedia.org/wiki/CURL | grep HTTP | cut -d ' ' -f 2 First solution: up and left

Naive, and effective. Press up to show the last command, keep tapping left until you get the the bit of the command you need to change, backspace to remove what you don't need and then enter what you do need

Second solution: bash vi mode

Bash has a vi mode, which can be activated by adding the following to your .bashrc .

set -o vi

If you're comfortable with vi you can now hit Escape to bounce into normal mode, Ctrl-P to go back to the last command, b a few times to get to the word you need to change... etc.

Vi mode is great - if you know a bit of vi. But you might not. So...

Third solution: quick substitution

How about something a little smarter:

^wikpedia^wikipedia

This is the bash quick substitution history expansion command - it runs the last command, substituting the first instance of the charaters after the first caret with the characters after the second caret.

Pretty neat huh? But that will olny work for the first instance - what if we need to replace every instance of wikpedia in the last command?

Fourth solution: full history substituton

Bash uses the ! character as the history expansion character - it is used to substitute a part of your current command with a previously executed command. One ! does nothing - but the previous command can be accessed with the !! sequence. So, to print out the last command, try:

echo !!

These history expansions can also take modifier options to change the string before it gets inserted. The syntax is <select>:<modifier> . For instance, to put the last command in quotes:

echo !!:q

And to perform a global substitution on it:

echo !!:gs/wikpedia/wikipedia

There is lots that can be done with the above syntax - just take a look at the documentation.

Fifth solution: retype the command

Seriously, by the time you've remembered how to do some of the above, wouldn't it have just been easier to type it out again.

Just don't mess it up this time, right?